|
|
| LCD FAQ | Notice for Application
1 Safety Guide
Liquid Crystal (LC) shouldn't be swallowed or touched, if happen to be stained by, please wash off with soap and water.
2 Application Guide
LCD is made up of glass, organic sealant, organic fluid and polarizer film. Assembled and adjusted with high degree of precision. Please avoid excessive shocks and presses. Glass can be easily cracked from rough handling, especially at corners and edges.
3 Assembly Guide
(1)When mounting the LCD on the PCB, we suggest to use the elastomer or soft band. Operators should glove, avoid touching by bare hand.
(2)Avoid pressing on the LCD overly, otherwise it will lead to work failure or reduced lifetime.
(3)Do not drive LCD with DC voltage or higher AC voltage than the Vop. They will also lead to reduced lifetime.
(4)Be careful in LCD transportation. If the LCD was stained, wipe off the dirt with alcohol.
(5)Tear off the protecting film before application. Do not contact the exposed polarizers with anything harder than an HB pencil lead.
(6)To clean dust off the display surface, wipe gently with cotton, chamois or other soft material soaked in petroleum benzin. Wipe off saliva or water drops immediately. Never scrub hard. Avoid organic solvent such as acetone, toluene, oil and fats.
(7)Before Heat-Seal or attach ACF, clean the LCD with alcohol.
(8)Be careful for the electrode, scratch will makes it disconnected.Page Down |
|
|
Your current location:jiyalcd>Cusdtomer service >Product Notes
Product Notes
